Support
Filtration Systems
PF98
The PF 98 can be easily identified by 3 main characteristics-
The first is the 2 support legs permanently mounted on the pump compartment lid.
The second is the square return flange where the water re-enters the pool.
The third is the front filtration lid is rectangular, but narrower than the wide part of the pump compartment lid.
There are 2 variations of the pump compartment lid for the PF 98. The two variants, P2 or P3, will be embossed between the legs on the underside of the lid.
P2 or P3 located on the underside of the lid. Look closely, sometimes they are hard to see.
PF 2000
The PF 2000 can be easily identified by 3 main characteristics-
The first is there is 1 support leg bolted on the pump compartment lid.
The second is the round return flange where the water re-enters the pool.
The third is that the front filter compartment lid has one corner cut at a 45 degree angle
The PF 2000 has 2 variations of the leg length. P2 or P3 will be embossed on the underside of the foot of the leg.
PF.I 180
The PF.I 180 can be easily identified by 2 main characteristics-
The first is this is a single bag filtration system. Open the filter lid and if there is only one skimmer basket/filter bag then it is a PF.I 180.
The second is the filter compartment lid is part of the coping around the pool’s edge.
PF.I 250
The PF.I 250 can be easily identified by 3 main characteristics-
The first is that the pump compartment lids have no support legs.
The second is the filter compartment and the pump compartment lids are the same width.
The third is that the lids are rectangles with no odd angles in either lid.
Pumps
PBI: 2-Speed Pump
The two speed pump is used when increased water discharge speed is needed for things such as swimming against the current (must use an AquaJet on second speed), or moving heavy debris around the pool.
NOTE: The white box is part of the pump and should never be removed. The green square box on the top of the motor should never be opened.
P18: 1Speed Pump
The one-speed pump is suitable for most pools and is especially well-suited for small ( smaller than 15’X30′) pools.
NOTE: The white box is part of the pump and should never be removed. The green square box on the top of the motor should never be opened.
